TJ11 Dual-Axis Potentiometer PWM Joystick

TJ11 Dual-Axis Potentiometer PWM Joystick - Image 3

TJ11 Dual-Axis Potentiometer PWM Joystick - Image 4

Product Features

Fingertipdaul-axis handle.
The spring return.
Angle detection method with center tapped potentiometer.
Maximum current 2mA direction switch.
Can be equipped with proportional amplifier board to directly drive hydraulic proportional valve

Category: [product_current_category_shortcode]

TJ11 series

Fingertip dauli-axis operating handle

Application range

This series of products are mainly used in engineering vehicles and industrial remote controls.

Technical Information

Electrical parameters

Power supply current	<36Vdc
Total resistance value	5KΩ
Electrical angle	± 30 °
Median voltage	48% ~ 52% (relative power supply voltage)
Median dead zone angle	± 2.5 °
Potentiometer maximum voltage	32 VDC
Power supply curren	t <36Vdc
Total resistance value	5KΩ
Electrical angle	± 30 °
Median voltage	48% ~ 52% (relative power supply voltage)
Median dead zone angle	± 2.5 °
Potentiometer maximum voltage	32Vdc
Potentiometer allows maximum power consumption	0.25W (25 ℃)
Direction switch Load capacity	2mA @ 30Vdc (resistive load)
Starting angle	± 3 ° ~ ± 5 °
Contact resistance	<200Ω

Mechanical parameters

Rocking angle	± 32 °
Mode of operation	Automatic spring reset, biaxial operation in any direction
Starting force	3.8N
Maximum operating force	12N
Limiting force	300N (H upper end is greater than 160N)
Service life	> 2 million times
Weight	125g

Environmental parameters

Working temperature	-30 ℃ ~ + 70 ℃
Storage temperature	-40 ℃ ~ + 85 ℃
Protection clas	s IP50 (above the installation panel)

Product selection

TJ11 Series

Operation method

1A	Single axis operation in front and back direction
2AC	any operation direction of dual axes (with guide groove

Output Signal

[Potentiometer type (power supply voltage <36Vdc)]

P051	5KQ potentiometer, 0 ~ 100% Vdc voltage output with front and rear direction switches

PWM with amplifier board

PWM 224	power voltage 24Vdc, 2 outputs
PWM 424	power supply voltage 24Vdc, 4 outputs
PWM 212	power voltage 12Vdc, 2 outputs
PWM 412	power supply voltage 12Vdc, 4 outputs

Upper end of handle

S	upper end of S-shaped handle, no button
L	upper end of L-shaped handle, no button
H	upper end of H-shaped handle with button

Terminal Potentiometer type

1 Switch common

2 Front direction switch

3 Rear direction switch

4 Slider of potentiometer

5 Potentiometer A

6 potentiometer center

7 Potentiometer B

8 Button switch

9 Button switch

file download