TJ11 series
Fingertip dauli-axis operating handle
Domaine d'application
This series of products are mainly used in engineering vehicles and industrial remote controls.
Informations techniques
Paramètres électriques
| Courant d'alimentation | <36Vdc |
| Total resistance value | 5KΩ |
| Electrical angle | ± 30 ° |
| Median voltage | 48% ~ 52% (relative power supply voltage) |
| Median dead zone angle | ± 2.5 ° |
| Potentiometer maximum voltage | 32 VDC |
| Power supply curren | t <36Vdc |
| Total resistance value | 5KΩ |
| Electrical angle | ± 30 ° |
| Median voltage | 48% ~ 52% (relative power supply voltage) |
| Median dead zone angle | ± 2.5 ° |
| Potentiometer maximum voltage | 32Vdc |
| Potentiometer allows maximum power consumption | 0.25W (25 ℃) |
| Direction switch Load capacity | 2mA @ 30Vdc (resistive load) |
| Starting angle | ± 3 ° ~ ± 5 ° |
| Contact resistance | <200Ω |
Paramètres mécaniques
| Angle de basculement | ± 32 ° |
| Mode de fonctionnement | Automatic spring reset, biaxial operation in any direction |
| Force de démarrage | 3.8N |
| Force maximale de fonctionnement | 12N |
| Force de limitation | 300N (H upper end is greater than 160N) |
| Durée de vie | > 2 million times |
| Poids | 125g |
Paramètres environnementaux
| Température de travail | -30 ℃ ~ + 70 ℃ |
| Température de stockage | -40 ℃ ~ + 85 ℃ |
| Protection clas | s IP50 (above the installation panel) |
Sélection des produits
TJ11 Series
Mode opératoire
| 1A | Single axis operation in front and back direction |
| 2AC | any operation direction of dual axes (with guide groove |
Output Signal
[Potentiometer type (power supply voltage <36Vdc)]
| P051 | 5KQ potentiometer, 0 ~ 100% Vdc voltage output with front and rear direction switches |
PWM with amplifier board
| PWM 224 | power voltage 24Vdc, 2 outputs |
| PWM 424 | power supply voltage 24Vdc, 4 outputs |
| PWM 212 | power voltage 12Vdc, 2 outputs |
| PWM 412 | power supply voltage 12Vdc, 4 outputs |
Extrémité supérieure de la poignée
| S | upper end of S-shaped handle, no button |
| L | upper end of L-shaped handle, no button |
| H | upper end of H-shaped handle with button |
Terminal Potentiometer type
| 1 Switch common |
| 2 Front direction switch |
| 3 Rear direction switch |
| 4 Slider of potentiometer |
| 5 Potentiometer A |
| 6 potentiometer center |
| 7 Potentiometer B |
| 8 Button switch |
| 9 Button switch |