TJ11 series
Fingertip dauli-axis operating handle
Application range
This series of products are mainly used in engineering vehicles and industrial remote controls.
Información técnica
Parámetros eléctricos
| Corriente de alimentación | <36Vdc |
| Total resistance value | 5KΩ |
| Ángulo eléctrico | ± 30 ° |
| Median voltage | 48% ~ 52% (relative power supply voltage) |
| Median dead zone angle | ± 2.5 ° |
| Potentiometer maximum voltage | 32 VDC |
| Power supply curren | t <36Vdc |
| Total resistance value | 5KΩ |
| Ángulo eléctrico | ± 30 ° |
| Median voltage | 48% ~ 52% (relative power supply voltage) |
| Median dead zone angle | ± 2.5 ° |
| Potentiometer maximum voltage | 32Vdc |
| Potentiometer allows maximum power consumption | 0.25W (25 ℃) |
| Direction switch Load capacity | 2mA @ 30Vdc (resistive load) |
| Starting angle | ± 3 ° ~ ± 5 ° |
| Contact resistance | <200Ω |
Parámetros mecánicos
| Ángulo de balanceo | ± 32 ° |
| Modo de funcionamiento | Automatic spring reset, biaxial operation in any direction |
| Fuerza de arranque | 3.8N |
| Fuerza máxima de funcionamiento | 12N |
| Fuerza limitadora | 300N (H upper end is greater than 160N) |
| Vida útil | > 2 million times |
| Peso | 125g |
Parámetros medioambientales
| Temperatura de trabajo | -30 ℃ ~ + 70 ℃ |
| Temperatura de almacenamiento | -40 ℃ ~ + 85 ℃ |
| Protection clas | s IP50 (above the installation panel) |
Selección de productos
TJ11 Series
Método de funcionamiento
| 1A | Funcionamiento de un solo eje en dirección delantera y trasera |
| 2AC | cualquier sentido de funcionamiento de los ejes dobles (con ranura guía |
Output Signal
[Potentiometer type (power supply voltage <36Vdc)]
| P051 | 5KQ potentiometer, 0 ~ 100% Vdc voltage output with front and rear direction switches |
PWM with amplifier board
| PWM 224 | power voltage 24Vdc, 2 outputs |
| PWM 424 | power supply voltage 24Vdc, 4 outputs |
| PWM 212 | power voltage 12Vdc, 2 outputs |
| PWM 412 | power supply voltage 12Vdc, 4 outputs |
Extremo superior de la empuñadura
| S | upper end of S-shaped handle, no button |
| L | upper end of L-shaped handle, no button |
| H | upper end of H-shaped handle with button |
Terminal Potentiometer type
| 1 Switch common |
| 2 Front direction switch |
| 3 Rear direction switch |
| 4 Slider of potentiometer |
| 5 Potentiometer A |
| 6 potentiometer center |
| 7 Potentiometer B |
| 8 Button switch |
| 9 Button switch |